Here is the 1/6 Scale Stasis kit for your 12 inch GI JOE sized Action Figure!
If you have any questions, just drop me a line
Frank
PAY PAL address is frankkcerney@yahoo.com
Price is $60.00 Plus 5.00 for shipping, or for those of you who are good at Higher Math, $65.00 Shipped. IF you want two Ill go 120 shipped, three 175 shipped. Huggers also available separately for $25.00 shipped. I don't do larger group dicosunts or wholesale, sorry! I did my best to keep the kit affordable, but resin and RTV have both gotten expensive, as has my time.
Please allow 2 Weeks for delivery. Should be less, and I'll do my best to ship same day.
Here is the actual kit of the tube. ****NOTE the Hugger is included but not shown in this photo!!** The bottom plate is also TRANSLUCENT to facilitate LIGHT! See more photos Below.
The Hugger kit with a battery for size reference. I might try casting them in a pale yellow. Heat the tail to Curl, just do so with enough heat, and be patient.
Hugger is included with the kit. Also sold separately for 25 shipped.
LIGHT SOURCE NOT INCLUDED!!!!! Here is a good demo on how tranclucent the bottoms are with a light source. Once ya Glue it to the Bottom Ring, Paint the OUTSIDE EXPOSED areas FLAT BLACK to trap any light, then silver. The Paint the Bottom of the tube a metalic gray.
The Bottom cap is the Thicker of the two. A 1 3/4 inch hole will need to be cut into it if you want to light your tube. Light source can be anything, LED, LAMP. Be creative. BE CAREFULL SANDING the excess resin off of your parts. Yeah, I know its a pain, but Id rather you have TWO much resin, then a part with HOLES IN IT! GO slowly, remember if you oversand, BONDO IS YOUR FRIEND.
Same Picture with Bottom Cut out.
Glue together and PAINT. Also, TOP CAP and TOP TRAINGLE are painted same color. So is control box and base under the control box.
Tube above is shown here partially assembled, but not painted. However, gives you an idea how it should look. Ill post pics as soon as I get a chance t build one myself!
Speaking of CONTROL BOX. Detailed intructions would be an insult to your intelligence. The Controls on the box are JUST WIRE and TUBING. Drill two Holes same diameter as the Copper wire, and then cut all the i insulation except for a "DONUT" and then paint Silver. They are supposed to look like TOGGLE SWITCHES.
Side shot for reference.
Top shot of the Hugger. I might try and cast these with color to the resin. However, no matter how ya paint it, its gonna look great. Just give it a nice wash with a darker color, and paint the nails. The underside is mostly reds and pinks, You can chose your own source of reference for that. HA!
Another shot of the Hugger, showing the Bottom. Might offer it with a TONGUE soon!
The Little Guy just WONT STAY IN! The rest of the kit is pretty obvious. The TUBES go into the holes, and NUTS go ontop of and on bottom of Plates and the control Box sits on top of the round disc that sits on top of the traingle plate. Picture should answer any questions, if not, email me. I will also add to these "instructions" as time permits. I also want to show how to light it, and also will be offering a base that is movie accurate. Ill get to these as soon as I get my full size consignment one done, which is pretty close to being finished.
KIT INCLUDES EVERYTHING SHOWN HERE!
Hope you Enjoy the kit!!
Thanks for the patience and More soon!!
